Filter
Top Products
DES-7200 Configuration Guide Chapter 1 Interface Configuration
1-26
(A,B,C,D) of 1000M twisted pair are OK.
Length
The line length, in meter, takes effect only for the pairs in
Ok state. In addition, some inaccuracy is possible
because the line length is calculated according to the
signal transferring time. The length of lines in Short or
Open states refers to the length from the port to the
defective line point.
1.6 LinkTrap Policy
Configuration
You can determine whether to send the LinkTrap of an interface according to
the interface configuration on a device. With this funciton enabled, when the
interface’s link status changes, the SNMP protocol will send a LinkTrap
message. Otherwise, it will not send a LinkTrap message. By default, this
funciton is enabled.
1.6.1 Configuration
Command
Command Function
DES-7200(config-if)# [no] snmp trap
link-status
Enable or disable the function of
sending the LinkTrap function of
this interface.
1.6.2 Configuration
Example
The following configuration shows how to configure the interface not to send
LinkTrap:
DES-7200(config)# interface gigabitEthernet 1/1
DES-7200(config-if)# no snmp trap link-status