Filter
Top Products
DES-7200 Configuration Guide Chapter 2 RIP
Configuration
2-28
Figure4 Topological diagram for RIP redistribution and default route
Networking Requirements
SwitchA, SwitchB and SwitchC are interconnected in the same network segment
and running RIP routing protocol. SwitchA and SwitchD are interconnected in the
same network segment and running OSPF routing protocol. Configure these four
devices to achieve the following goals:
SwitchA can learn the OSPF routes advertised by SwitchD;
SwitchA can redistribute OSPF routes to RIP;
SwitchA advertises the redistributed routes to SwitchB and SwitchC;
SwitchC advertise the default route to SwitchA and SwitchB.
Configuration Tips
Configure to redistribute OSPF routes to RIP in the RIP process of SwitchA;
Configure to advertise the default route on the corresponding interface of
SwitchC;
Configuration Steps
# SwitchA:
! Configure Ethernet interface
DES-7200(config)#interface FastEthernet 0/1