Filter
Top Products
DES-7200 Configuration Guide Chapter 5 POE Management Configuration
5-3
Step 3
poe enable | no poe enable
Enable/disable the PoE of a port
Step 4 Return to privileged EXEC mode
End
Step 5
show run
Verify the configuration
Step 6
startup-con
copy running-config
Save the settings into the parameter file.
fig
For example, enable/disable the PoE of port 1 on line card 1:
gigabitEthernet 1/1
enable
5.2.3
DES-7200#
onfigure
DES-7200# c
DES-7200 (config)#interface
DES-7200(config-if)# poe
DES-7200(config-if)# no poe enable
DES-7200(config-if)# end
DES-7200#
Setting the Minimum
Allowed Voltage of the POE
System
Currently, the Ethernet port of the switch supporting POE can provide the minimum
allowed
voltage of 45V. You can set the minimum allowed voltage according to the
actual need, within the range of 45000 mv to 47000 mv. When the output voltage is
cted to all
You can use the following commands to set the minimum allowed voltage of the power
s f th se do the following confi
T S oltage o
lower than the minimum allowed value due to reasons such as power faults, the
equipment will automatically turn off the power supply of the devices conne
ports.
upply o e port. Plea guration in the global mode.
able-3: et the Minimum Allowed V f the POE System
Step 1
Configure
Enter the configuration mode
Step 2
poe-power lower lower | no
Set the minimum allowed voltage of the
inimum
poe-power lower
POE system/restore the m
allowed voltage to the default value
Step 3 Return to privileged EXEC mode
End
Step 4
show run
Verify the configuration
Step 5
startup-config
Save the settings into the parameter file.
copy running-config
By default, the minimum output power of a port is 45v.
mum output power of the system to 46v.
DES-7200# configure
For example, set the mini
DES-7200#