Filter
Top Products
DES-7200 Configuration Guide Chapter 1 VRRP Configuration
1-9
Command Purpose
Or：
DES-7200(config-if)# vrrp ipv6 group track
{ipv6-global-address | {ipv6-linklocal-address
interface-type number}} [[[interval
interval-value] timeout timeout-value]
priority]
Configure the IP address monitored by IPv6
VRRP backup group.
DES-7200(config-if)# no vrrp ipv6 group
track {ipv6-global-address |
{ipv6-linklocal-address interface-type
number}}
Remove the IP address monitored by IPv6
VRRP backup group.
By default, there is no IP address configured to be monitored by the VRRP backup
group. The parameter interval–value ranges 1~3600s. If the parameter interval–value
is default, the system will use the default value 3s. The parameter timeout–value
ranges 1~60s. If the parameter timeout–value is default, the system will use the default
value 1s. Note that the timeout-value must be less than or equal to interval-value. The
parameter priority ranges 1~255. If the parameter priority is default, the system will use
the default value 10. To configure VRRP IPv6 address, you must first configure VRRP
IPv6 link-local address. If the monitored address is a link-local address, the interface
shall be specified as well.
1.3.10 Setting the Learning
Function of VRRP
Advertisement Timer Device
Once the timer learning function is enabled, if the current router is VRRP backup router,
after setting the timer learning function, the router will learn VRRP advertisement
sending interval from VRRP advertisement of the master router and calculate the
failure judgment interval of master router. It does not calculate by VRRP advertisement
sending interval set locally. Use this command to synchronize the VRRP
advertisement timer between the backup router and master router.
Command Function
DES-7200(config-if)# vrrp group timers learn
Set the timer learning function.
DES-7200(config-if)# no vrrp group timers
learn
Delete the timer learning function.
By default, the VRRP group timer learning function is not set.