Filter
Top Products
DES-7200 Configuration Guide Chapter 3 MPLS QOS
Configuration
3-24
exceeded 0 packets, 0 bytes; action: none 0
violated 0 packets, 0 bytes; action: none 0
cbucket 0, cbs 0; ebucket 0 ebs 0
Note
Mark count is currently not supported by switches.
3.4.6 Showing MPLS EXP
copying state
Execute the following steps to display MPLS EXP copying state
Command Function
show mls qos mpls
Display information about MPLS
EXP copying
Example:
DES-7200# show mls qos mpls
Default mpls copy exp：enable
Default mpls propagate-exp none：disable
DES-7200#
3.5 Typical example of
configuring MPLS QoS
DiffServ tunneling mode
3.5.1 Networking
requirements
PE devices shall allow the mutual mapping between IP QoS information
and MPLS QoS information.
P device shall allow MPLS EXP copying during label switching.
DES-7200 series devices are used for PE-1, P and PE-2.