Filter
Top Products
DES-7200 Configuration Guide Chapter 7 RLDP Configuration
7-7
Command Function
DES-7200(config)# rldp
detect-interval interval
Configure the detection interval within the
range 2-15s, 3s by default.
DES-7200(config)# end
Return to the privileged mode.
The no option of the command restores the value to its default.
7.2.5 Configuring the Maximum
RLDP Detection Times
If the port with RLDP enabled cannot receive messages from neighbors in the
maximum detection period (maximum detection times X detection interval), that
port will be diagnosed as faulty. See the Overview for details of the fault types.
In the global configuration mode, follow these steps to configure the RERP
maximum detection times:
Command Function
DES-7200(config)# rldp detect-max
Num
Configure the maximum detection times,
num range 2-10, 2 by default.
DES-7200(config)# end
Return to the privileged mode.
The no option of the command restores the value to its default.
Note
The maximum detection times only take effect in the unidirectional
link detection and bidirectional link detection, and will not take
effect if only loop detection is enabled on a port.
7.2.6 Restoring the RLDP Status
of the Port
The port with shutdown-port troubleshooting method configured cannot resume
the RLDP detection actively after a fault occurs. If the user confirms the fault
removed, run the recovery command to restart the RLDP on the shutdown port.
This command sometimes may make the other ports with detection errors
resume.
In the privileged mode, follow these steps to resume the RLDP detection of the
port:
Command Function
DES-7200# rldp reset
Make any port with RLDP detection failure
resume the detection.