Filter
Top Products
DES-7200 Configuration Guide Chapter 11 GVRP Configuration
11-3
DES-7200(config)# gvrp enable
DES-7200(config)# end
11.2.4 Enable Dynamic
VLAN Creation
When a port receives messages (limited only to Joinin Joinempty) indicating a VLAN
which doesn't exist on the local device, GVRP may create this VLAN. The user can
control whether or not to create VLAN dynamically.
Enable dynamic VLAN creation:
Command Function
DES-7200(config)# [no] gvrp
dymanic-vlan-creation enable
Enable GVRP to create VLAN dynamically
(if it is disabled)
The user cannot change the parameters of dynamic VLANs created by GVRP.
Configuration example:
DES-7200# configure
Enter configuration commands, one per line. End with CNTL/Z.
DES-7200(config)# gvrp dymanic-vlan-creation enable
DES-7200(config)# end
11.2.5 Configure the GVRP
VLAN
In the context without STP (Spanning-tree protocol), all available ports can be GVRP
participants.
In the context with SST (Single Spanning-tree), only ports showing "Forwarding" state in
the current SST Context can be GVRP participants. In the context with MST (Multiple
Spanning-tree), GVRP can run in the Spanning-tree Context which VLAN 1 is affiliated
with, and the user cannot specify other Spanning-tree Contexts.
11.2.6 Configure Port
Registration Mode
There are two port registration modes:
GVRP Registration Normal
GVRP Registration Disabled
Configuring a port in normal registration mode allows dynamic creation (if dynamic
VLAN creation is enabled), registration, and deregistration of VLANs on the port.