Filter
Top Products
DES-7200 Configuration Guide Chapter 1 SNMP
Configuration
Command Function
DES-7200(config)# snmp-server
user username roupname {v1 | v2
| v3 [encrypted] [auth { md5|sha }
auth-password ] [priv des56
priv-password] } [access {[ipv6
ipv6_aclname] [aclnum | aclname] }]
Configure the user information.
To remove the specified user, execute the no snmp-server user username
groupname command in the global configuration mode.
1.2.4 Configuring Host Address
In special cases, the SNMP Agent may also proactively send messages to the
NMS.
To configure the NMS host address that the SNMP Agent proactively sends
messages to, execute the following commands in the global configuration
mode:
Command Function
DES-7200(config)# snmp-server
host {host-addr | ipv6 ipv6-addr }
[vrf vrfname] [traps] [ version {1|2c
|3 [auth | noauth | priv]}]
community-string [udp-port
port-num] [type]
Set the SNMP host address, vtf,
community string, message type (or
security level in SNMPv3).
1.2.5 Configuring SNMP Agent
Parameters
You can configure the basic parameters of the SNMP Agent, including contact,
device location and sequence number. With these parameters, the NMS knows
the contact, location and other information of the device.
To configure the SNMP agent parameters, run the following commands in the
global configuration mode:
Command Function
DES-7200(config)# snmp-server
contact text
Configure the contact.
DES-7200(config)# snmp-server
location text
Configure the location.
DES-7200(config)# snmp-server
chassis-id number
Configure the sequence number.
1-8